Keysight P937 A Series Service Manual page 74

Removal and Replacement Procedures
Module Replacement Procedure
Replacement Procedure
1. Reverse the order of the removal procedure.
2. Remember to place the light pipe back into the module.
3. Perform the post-repair steps, verifications, and performance tests that
When slide in the module, make sure the PCB board sitting in between the
groove on the both side . Refer figure below.
72
pertain to this removal procedure. Refer to
page 73.
"Post-Repair Procedures" on
Keysight P937xA PXIe Service Guide