Keysight P937 A Series Service Manual page 71

Removal and Replacement Procedures
Chassis Replacement Procedure
Replacement Procedure
1. Reverse the order of the removal procedure.
2. Remember to place the light pipe back into the module. Refer to the
3. Adhere and properly align appropriate nameplate overlay into the pocket
4. Attach the secondary plate P9375-00007 using 0515-1227 (x4) screws to
5. Perform the post-repair steps, verifications, and performance tests that
Figure 5-6 Nameplate Overlay for P937xA
Keysight P937xA PXIe Service Guide
5-5 on page 67.
shown below Figure 5-6 on page
overlay included with the kit that matches your analyzer. Rub down the
overlay with moderate finger pressure.
the new chassis.
pertain to this removal procedure. Refer to
and Troubleshooting", on page 25
69. There should also be a nameplate
Chapter 3, "Tests, Adjustments,
Figure
69