Test Management Environment (Tme) Performance Tests - Keysight P937 A Series Service Manual

Tests, Adjustments, and Troubleshooting

Test Management Environment (TME) Performance Tests

Test Management Environment (TME) Performance Tests
The performance tests verify the electrical performance of your USB-network
analyzer. For more information, refer to the TME webpage at
http://cal.software.keysight.com.
This section lists the test equipment needed to run performance tests. Models
for each test equipment category are given in order of preference. Alternate
models are also listed but should be considered a lower priority. All equipment
is Keysight, Agilent, or Hewlett Packard unless otherwise specified. Refer to
each individual test for specific setup configurations. The computer and all test
equipment are connected to the unit under test (UUT) using GPIB and PXI.
Requires a PC controller to run the (TME) Performance Tests.
Table 3-2 Required Test Equipment (TME Performance Testing)
Test Equipment
PNA network analyzer
Power meter
Power sensor
(Refer to Guidelines for
Ordering Power-Sensor
Calibration Service)
Frequency counter
Frequency reference
Dynamic accuracy test set
Compression test set
Keysight P937xA PXIe Service Guide
Recommended Model
N5245A
N1914
N8485A
5320A Option 115
Frequency counter internal
b
U3020A-D01
U3070A-K01
a
A
Alternate Model
N5222A
N5224A
N5225A

N5242A
N5244A
N5245AS

E8363C
E8364C
N1912A

E4419A
E4418A
None
53131A
53132A Options 010 or 012,
and 124
53181A Options 010 and 124
House standard
None
None
45