Replacing The Laser Driver Board - Christie GS Series Service Manual

Replacing the laser driver board

To remove the laser driver board, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove the connector board.
See Replacing the connector board
4. Remove the left-side cover.
See Removing the left-side cover
5. Remove the complete light engine.
See Replacing the complete light engine
6. Cut off the cable tie.
7. Remove the mylar.
8. Remove the power supply shielding.
See Replacing the power supply
9. Remove the six M3 screws with a Phillips #1 screwdriver securing the laser driver board.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
on page 51.
on page 69.
on page 74.
on page 53.
on page 66.
on page 61.
Printed circuit boards and sensors
76