Christie GS Series Service Manual page 71

Item Male connector on
connector board
J J58 ENGINE
K J10 MB TO KEYPAD
CONN
L J28 FAN1
M J27 FAN2
N J14 RS232
5. Remove the harnesses from the clips.
6. On the top side of main board, remove the ten M3 screws with a Phillips #1 screwdriver.
7. On the I/O cover, remove the eight hex screws with a M3 socket driver.
8. Lift up the main board.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
Description
White connector, and a black wire tube (30 pin)
White connector, and a black wire tube (30 pin)
Composed of black, blue, gray, and brown wires, a
white connector, and a black wire tube (four pin)
Composed of black, blue, gray, and brown wires, a
white connector, and a black wire tube (four pin)
Composed of black, white, and red wires, a white
connector, and a red wire tube (four pin)
Printed circuit boards and sensors
Figure
71