Christie GS Series Service Manual page 62

See Removing the left-side cover
5. Remove the complete light engine.
See Replacing the complete light engine
6. Remove the three M3 screws with a Phillips #1 screwdriver securing the power supply
shielding.
7. Lift up the power supply shielding.
8. On the power supply, disconnected the laser driver to power supply harnesses.
9. Remove the power supply shielding.
10. Unplug the four connectors.
Power supply to
main board
11. To replace the power supply, remove the seven M3 ground screws with a Phillips #1
screwdriver.
12. To re-install, follow these steps in reverse order.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
on page 53.
on page 66.
Interlock switch
Thermal switch
Electronics
AC inlet
62