Christie GS Series Service Manual page 75

Item Male connector on
connector board
R J8 MB
S J5 HL
T J9 LIGHT SENSOR
U J10 FW MOTOR
V J6 VB
W J1 V-motor
X J2 H-motor
4. Remove the harnesses from the clips.
5. To disassemble the connector board, remove the three M3 screws with a Phillips #1
screwdriver.
6. Replace the connector board.
7. To re-install, follow these steps in reverse order.
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
Description
White connector, and a black wire tube (30 pin)
Composed of two white wires, a white connector, and a
black wire tube (two pin)
Composed of black, yellow, and red wires, a white
connector, and a black wire tube (six pin)
FPC cable (four pin)
Composed of two black wires, a white connector, and a
black wire tube (two pin)
Composed of yellow, white, red, and blue wires, a white
connector, and a black wire tube (four pin)
Composed of yellow, white, red, and blue wires, a white
connector, and a black wire tube (four pin)
Printed circuit boards and sensors
Figure
75