Siemens SINUMERIK 840Di Function Manual page 635

Basic machine

Hide thumbs Also See for SINUMERIK 840Di:

Table of Contents

Example for call of operator panel reset

For MD20108 $MC_PROG_EVENT = 'H04'

PROC PROG_EVENT DISPLOF

Start with RESET key

Control with MD PROG_EVENT_IGN_INHIBIT

The part program whose name is in MD11620 $MN_PROG_EVENT_NAME and which was

stored in one of the directories /_N_CUS_DIR/, /_N_CMA_DIR/, or /_N_CST_DIR/ or the

_N_PROG_ENENT_SPF program (default) is automatically started with the RESET key and

executed up to the end, regardless of any read-in disable, if the following MD settings are

$MC_PROG_EVENT_IGN_INHIBIT= 'H04F'

$MC_PROG_EVENT_MASK= 'H04F'

For block search (SSL):

If MD11450 $MN_SEARCH_RUN_MODE Bit 1 = TRUE, activation of the last action block

also implicitly activates "Automatic ASUB start" after block search of

/_N_CMA_DIR/_N_PROG_EVENT_SPF.

For further explanation, refer to "Automatic start of an ASUB after block search" in the

"Program Test" section.

For further explanation of power-up of the control, see

References: /IAD/, "Power-On and Power-Up"

Mode Group, Channel, Program Operation, Reset Response (K1)

Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0

2.7 Program operation mode

Deactivate DRF offsets

Detailed Description

Show Quick Links

Chapters

Table of Contents