Siemens SINUMERIK 840Di Function Manual page 1125

FRate:
InPos:
Error:
State:
FUNCTION FC 18: VOID
VAR_INPUT
END_VAR
VAR_OUTPUT
END_VAR
Description of formal parameters
The table below lists all formal parameters of the SpinCtrl function.
Signal
Start
Stop
Funct
Power Line Basic PLC Program (P3)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Cutting rate
Setpoint speed is output
With position error = "1"
Error code
Start:
Stop:
Funct:
Mode:
AxisNo:
Pos:
FRate:
InPos:
Error :
State :
I/O Type
I Bool
I Bool
I Byte
BOOL ;
BOOL ;
BYTE ;
BYTE ;
INT ;
REAL;
REAL;
BOOL ;
BOOL ;
BYTE ;
Value range Remarks
Start spindle control from PLC
Stop spindle control from PLC
1 to B#16#0B 1: Position spindle
2: Rotate spindle
3: Oscillate spindle
4: Indexing axis
5: PosAxis metric
6: PosAxis inch
7: PosAxis metric with handwheel override
8: PosAxis inch with handwheel override
9: Rotate spindle with gear stage selection
A: Rotate spindle with constant cutting rate
(m/min)
B: Rotate spindle with constant cutting rate
(feet/min)
Detailed description
2.12 Block descriptions
//SpinCtrl
2-213