Siemens SINUMERIK 840Di Function Manual page 706

Data Lists
5.1 Machine data
5.1.2.3 Reset response
Number Identifier: $MC_
20110 RESET_MODE_MASK
20112 START_MODE_MASK
20118 GEOAX_CHANGE_RESET
20120 TOOL_RESET_VALUE
20121 TOOL_PRESEL_RESET_VALUE
20130 CUTTING_EDGE_RESET_VALUE
20140 TRAFO_RESET_VALUE
20150 GCODE_RESET_VALUES
20152 GCODE_RESET_MODE
20156 MAXNUM_GCODES_EXT
22620 START_MODE_MASK_PRT
5.1.2.4 Auxiliary function settings
Number Identifier: $MC_
22000 AUXFU_ASSIGN_GROUP
22010 AUXFU_ASSIGN_TYPE
22020 AUXFU_ASSIGN_EXTENSION
22030 AUXFU_ASSIGN_VALUE
22200 AUXFU_M_SYNC_TYPE
22210 AUXFU_S_SYNC_TYPE
22220 AUXFU_T_SYNC_TYPE
22230 AUXFU_H_SYNC_TYPE
22240 AUXFU_F_SYNC_TYPE
22250 AUXFU_D_SYNC_TYPE
22260 AUXFU_E_SYNC_TYPE (available soon)
22300 AUXFU_AT_BLOCK_SEARCH_END
22400 S_VALUES_ACTIVE_AFTER_RESET
22410 F_VALUES_ACTIVE_AFTER_RESET
22500 GCODE_OUTPUT_TO_PLC
22510 GCODE_GROUPS_TO_PLC
22550 TOOL_CHANGE_MODE
22560 TOOL_CHANGE_M_CODE
5-4
Description
Initial setting at RESET
Initial setting at special NC Start after power-up and at
RESET
Allow automatic geometry axis change
Tool whose length compensation is selected during
powerup (Reset/part program end)
Preselected tool whose length compensation is
selected in powerup (Reset/part program end)
Tool cutting edge on power-up (Reset/part program
end)
Active transformation on RESET
Reset G groups
G code basic setting at RESET
Reset behavior of the external G groups
Initial setting at special NC Start after power-up and at
RESET
Description
Auxiliary function group
Auxiliary function type
Auxiliary function extension
Auxiliary function value
Output timing of M functions
Output timing of S functions
Output timing of T functions
Output timing of H functions
Output timing of F functions
Output timing of D functions
Output timing of E functions.
Output of auxiliary functions after block search
S function active after RESET
F function active after reset
G functions to PLC
G codes that are output to the NCK/PLC interface on
block change/RESET
New tool offset for M function
M function for tool change
Mode Group, Channel, Program Operation, Reset Response (K1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0