Siemens SINUMERIK 840Di Function Manual page 1052

Detailed description
2.12 Block descriptions
Parameterization:
Signal
PIService
Unit
Reset monitoring values (TRESMO)
This PI service resets the monitoring values of the designated edges of the designated tools
to their setpoint (initial) values.
This only relates to tools with active monitoring.
Compare this with the RESETMON NC command.
Parameterization:
Signal
PIService
Unit
WVar1
WVar2
WVar3
2-140
Type Value range
ANY PI. TMRASS
INT 1 to 10
Type Value range
ANY PI. TRESMO
INT 1 to 10
WORD -max ..max
WORD 0 ... max.
WORD 0 ...15
Meaning
Reset active status
TO area
Meaning
Reset monitoring values
TO area
Tool Number
0: Applies to all tools
>0: Applies only to this tool
<0: Applies to all sister tools of the specified T No.
D number
>0: Monitoring of specified edge of specified tools is
reset.
0: Monitoring of all edges of specified tools is reset.
Monitoring types
Type of monitoring to be reset.
This parameter is binary-coded.
1: Tool-life monitoring is reset.
2: Count monitoring is reset.
4: Wear monitoring is reset.
8: Total-offset monitoring is reset.
Combinations of monitoring types can be reset by adding
the values above.
0: All active tool-monitoring functions ($TC_TP9) are
reset.
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Power Line Basic PLC Program (P3)