Siemens SINUMERIK 840Di Function Manual page 1040

Detailed description
2.12 Block descriptions
Parameterization
Signal
PIService
Unit
WVar1
PI service: TMCRTO
Create tool
Function:
Creation of a tool with specification of an identifier, a duplo number and a T number
(optional). The tool is entered as existing in the tool directory area (TV). The first cutting
edge "D1" (with zero contents) is created for tool offsets in the TO block. "D1" (with zero
contents) is also set up for the monitoring data in the TS block, and simultaneously with zero
contents for the OEM cutting edge data in the TUE block - if one is present. The TD block
contains the identifier, duplo number and number of cutting edges (=1) for the T number that
is entered optionally or allocated by the NCK. If a TU block exists, it will contain the data set
for the tool.
After execution of the PI, the T number of the tool created is available in the TV block under
TnumWZV.
Note
Before and after this PI service, the MMCSEM PI service must be called up with the
associated parameter WVar1 for this PI service. See PI service MMCSEM for more
information.
Parameterization
Signal
PIService
Unit
WVar1
WVar2
Addr1
T number > 0 means a T number must be specified
T number = -1 means that the NCK should allocate a T number
The example shows T number = -1 ⇒ T number assigned by NCK
2-128
Type
ANY
INT
INT
Type
ANY
INT
INT
INT
STRING
Value range
PI.CREACE
1, 2
Value range
PI.TMCRTO
1, 2
max. 32 characters
Power Line Basic PLC Program (P3)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
Meaning
Create cutting edge
TOA
T number
Meaning
Create tool
TOA
T number
Duplo number
Tool identifier