National Instruments Corporation GPIB-1014P User Manual page 55

Register Bit Descriptions
Bit Mnemonic
2w LOKC
2r LOKC IE
1w REMC
1r REMC IE
0r ADSC
0w ADSC IE
GPIB-1014P User Manual
Description
Lockout Change Bit
Lockout Change Interrupt Enable Bit
LOKC is set by:
any change in LOK
LOKC is cleared by:
pon + (Read ISR2)
Notes:
LOK: ISR2[5]r
pon: power on reset
Read ISR2: Bit is cleared immediately after it is read.
LOKC is set whenever there is a change in the LOK bit, ISR2[5]r,
(REMS + RELS).
Remote Change Bit
Remote Change Interrupt Enable Bit
REMC is set by:
any change in REM
REMC is cleared by:
pon + (Read ISR2)
Notes:
REM: ISR2[4]r
pon: power on reset
Read ISR2: Bit is cleared immediately after it is read.
REMC is set whenever there is a change in the REM bit, ISR2[4]r,
(REMS + RELS).
Addressed Status Change Bit
Addressed Status Change Interrupt Enable Bit
ADSC is set by:
[(any change in TA) + (any change in LA)
+ (any change in CIC) + (any change in MJMN)] & -(lon + ton)
ADSC is cleared by:
pon + (Read ISR2)
4-18
Section Four
© National Instruments Corporation