National Instruments Corporation GPIB-1014P User Manual page 165

L
LA (Listener Active Bit), 4-21
lines. See signals and lines.
Listen command
codes for, 4-29
description, 4-33
Listen in Continuous Mode command
codes for, 4-29
description, 4-33
LLO (Local Lockout) command, 4-26
Local Unlisten command
codes for, 4-29
description, 4-33
LOK (Lockout Bit), 4-16
LOKC (Lockout Change Bit), 4-17
LOKC IE (Lockout Change Interrupt Enable Bit), 4-17
lon (Liston Only Bit), 4-22
LPAS (Listener Primary Addressed State Bit), 4-20
M
messages, types of, E-1
µPD7210 interface registers (chart), 4-4
MJMN (Major-Minor Bit), 4-21
MLA (My Listen Address) command, 4-26
mnemonics for registers
alphabetical list with definitions, F-1 to F-8
clues to understanding, 4-3
MSA,PPD (My Secondary Address or Parallel Poll Disable) command,
4-26
MSA,PPE (My Secondary Address or Parallel Poll Enable) command,
4-26
MTA (My Talk Address) command, 4-26
multiline GPIB commands (table), D-2 to D-3, 4-25 to 4-26
N
NDAC (not data accepted) signal, E-2
Non-Valid Secondary Command or Address command
codes for, 4-28
description, 4-32
NRFD (not ready for data) signal, E-2
O
operating environment, A-1
optional equipment for GPIB-1014P, 1-3
© National Instruments Corporation Index-7
Index
GPIB-1014P User Manual