National Instruments Corporation GPIB-1014P User Manual page 26

General Description
capability, but the interpretation is software dependent. All Controller functions as specified by the
IEEE-488 standard are included in the GPIB-1014P. These include the capability to:
• Be System Controller
• Initialize the interface
• Send Remote Enable
• Respond to Service Request
• Send multiline command messages
• Receive control
• Pass control
• Conduct a Parallel Poll
• Take control synchronously or asynchronously
Table 2-4 indicates the GPIB-1014P IEEE-1014 compliance levels.
Table 2-4. GPIB-1014P IEEE-1014 Compliance Levels
Compliance Notation
Bus Slave Compliance Levels
D08(O)
A16
ADO
Interrupter Compliance Levels
D08(O)
ROAK
I1 through I7
GPIB-1014P User Manual
8-bit data path to TLC
Responds to 16-bit short I/O addresses when specified
on the address modifier lines
Accommodates Address Only cycles
Provides an 8-bit status/ID byte on D00 through D07
Releases its interrupt request line when the interrupt
handler acknowledges the interrupt
Full support of all seven interrupt priority levels and
interrupt acknowledge daisy chain
2-12
Description
© National Instruments Corporation
Section Two