National Instruments Corporation GPIB-1014P User Manual page 167

R
READ sample program, C-11 to C-12
RECEIVE-RCV sample program, C-9 to C-10
registers
format for description of, 4-2
GPIB TLC interface registers (chart), 2-3
interface registers
Address Mode Register (ADMR), 4-22 to 4-24
Address Status Register (ADSR), 4-20 to 4-21
Auxiliary Mode Register (AUXMR), 4-27 to 4-34
Command/Data Out Register (CDOR), 4-7
Command Pass Through Register (CPTR), 4-25 to 4-26
Data In Register (DIR), 4-6
hidden registers, 4-34 to 4-46
Interrupt Mask Register 1 (IMR1), 4-8 to 4-13
Interrupt Status Register 1 (ISR1), 4-8 to 4-13
Interrupt Status Register 2 (ISR2), 4-14
µPD7210 interface registers (chart), 4-4
overview, 4-3 to 4-4
Serial Poll Mode Register (SPMR), 4-19
Serial Poll Status Register (SPSR), 4-19
writing to hidden registers, 4-5
mnemonics for, 4-3
register map, 4-1 to 4-2
size of, 4-2
terminology related to, 4-2 to 4-3
REM (Remote Bit), 4-16
REMC (Remote Change Bit), 4-17
REMC IE (Remote Change Interrupt Enable Bit), 4-17
REMOTE ENABLE-REN sample program, C-8
REN (remote enable) line, E-3
REOS (END on EOS Received Bit), 4-38
reset. See system reset.
Return to Local (rtl) command
codes for, 4-28
description, 4-31
RFD Holdoff mode, 4-6, 4-39
RFD (Ready for Data) message, 4-6
rsv (Request Service Bit), 4-19
S
S8 (Serial Poll Status Byte), 4-19
S (Status Bit Polarity Bit), 4-37
sample programs
68000 code, C-2 to C-4
COMMAND SEND-CSEND, C-17
DATA SEND-DSEND, C-13 to C-14
INITIALIZE-INIT, C-5 to C-6
© National Instruments Corporation Index-9
Index
GPIB-1014P User Manual