National Instruments Corporation GPIB-1014P User Manual page 25

Section Two
Table 2-3. GPIB-1014P IEEE-488 Interface Capabilities (continued)
Capability Code
SR1
RL1
PP1
PP2
DC1
DT1
C1, 2, 3 ,4, 5
E1, E2
The GPIB-1014P has complete Source and Acceptor Handshake capability. The GPIB-1014P can
operate as a basic Talker or Extended Talker and can respond to a Serial Poll. It can be placed in a
Talk Only mode, and it is unaddressed to talk when it receives its listen address. The interface can
operate as a basic Listener or Extended Listener. It can be placed in a Listen Only mode, and it is
unaddressed to listen when it receives its talk address. The GPIB-1014P has full capabilities for
requesting service from another Controller. It can be placed in local mode, but the interpretation of
remote versus local mode is software-dependent. The interface has full Parallel Poll capability,
although local configuration requires software assistance. It also has Device Clear and Trigger
© National Instruments Corporation
Description
Complete Service Request capability
Complete Remote/Local capability with software
interpretation
Remote Parallel Poll configuration
Local Parallel Poll configuration with software assist
Complete Device Clear capability with software
interpretation
Complete Device Trigger capability with software
interpretation
Complete Controller capability
System Controller
Send IFC and take charge
Send REN
Respond to SRQ
Send interface messages
Receive control
Pass control
Pass Control to Self
Parallel Poll
Take control synchronously
Tri-state bus drivers with automatic switch to open
Collector drivers during Parallel Poll
2-11
General Description
GPIB-1014P User Manual