Figure 3-3. Configuration For Vmebus Base Address 1000 Hex (Default Setting) - National Instruments Corporation GPIB-1014P User Manual

Configuration and Installation
Dual In-line Package (DIP) switches U28 and U29 select the base address. U29 selects address
lines A8 through A15, and U28 selects address lines A4 through A7. Press the side labeled 0 to
select a logical zero for the corresponding address bit. Press the side labeled 1 to select a logical
one. Figure 3-3 shows the configuration for the base address default setting 1000 hex.
Key
This side down for logic 1
This side down for logic 1

Figure 3-3. Configuration for VMEbus Base Address 1000 hex (default setting)

GPIB-1014P User Manual
= the side you press down for Base Address 1000 hex
= not involved in Base Address selection
3-4
This side down for logic 0
I1
I2
I3
A4
A5
0
A6
A7
U28
This side down for logic 0
A8
A9
0
A10
A11
A12
A13
1
A14
A15
U29
© National Instruments Corporation
Section Three