Section Three; Configuration And Installation; Configuration - National Instruments Corporation GPIB-1014P User Manual

Section Three

Configuration and Installation

This section describes the configuration and installation of the GPIB-1014P.

Configuration

Before installing the GPIB-1014P in the VMEbus backplane, the following options must be
configured with hardware jumpers or switches that are located on the GPIB-1014P interface board:
• Access Mode (W2)
• VMEbus Base Address (U28, U29)
• VMEbus Interrupt Configuration (W3)
• Interrupt Status/ID Vector (U7)
• GPIB Cable Shield Grounding (W1)
© National Instruments Corporation 3-1 GPIB-1014P User Manual