National Instruments Corporation GPIB-1014P User Manual page 161

Controller function
becoming controller-in-charge (CIC) and active controller, 5-2 to 5-3
Controller-In-Charge (CIC) and System Controller, E-2
going from active to idle, 5-4
going from active to standby, 5-3
going from standby to active, 5-4
operation of, E-1 to E-2
sending remote multiline messages (commands), 5-3
CPT[7-0] (Command Pass Through Bits 7 through 0), 4-25 to 4-26
CPT (Command Pass-Through Bit), 4-8 to 4-9
CPT ENABLE (Command Pass Through Enable Bit), 4-41
CPT IE (Command Pass-Through Interrupt Enable Bit), 4-8 to 4-9
CPTR. See Command Pass Through Register (CPTR).
D
Data In Register (DIR), 4-6
data lines, E-2
data or data messages, E-1
DATA SEND-DSEND sample program, C-13 to C-14
data transfer features, 2-5
DAV (data valid) signal, E-3
DCL (Device Clear) command, 4-26
DEC (Device Clear Bit), 4-11
DEC IE (Device Clear Interrupt Enable Bit), 4-11
DET (Device Execute Trigger Bit), 4-10
DET IE (Device Execute Trigger Interrupt Enable Bit), 4-10
DHDC (DAC Holdoff on DCAS Bit), 4-42
DHDT (DAC Holdoff on DTAS Bit), 4-42
DI (Data In Bit), 4-12 to 4-13
DI IE (Data In Interrupt Enable Bit), 4-12 to 4-13
DIR. See Data In Register (DIR).
DIR[7-0] (Data In Bits 7 through 0), 4-6
Disable System Control command
codes for, 4-29
description, 4-34
DL (Disable Listener Bit), 4-44
DL0 (Disable Listener 0 Bit), 4-43
DL1 (Disable Listener 1 Bit), 4-45
DMAI (DMA Input Enable Bit), 4-16
DMAO (DMA Out Enable Bit), 4-16
DO (Data Out Bit), 4-12
DO IE (Data Out Interrupt Enable Bit), 4-12
documentation for GPIB-1014P, E-7, vi
don't care bits, definition, 4-2
DT (Disable Talker Bit), 4-44
DT0 (Disable Talker 0 Bit), 4-43
DT1 (Disable Talker 1 Bit), 4-45
© National Instruments Corporation Index-3
Index
GPIB-1014P User Manual