In a non-partitioned library, active capacity is automatically assigned after installing
the hardware activation file. The automatic configuration activates storage slots in the
order specified by the Default Capacity Policy. However, you can customize the
configuration and select which slots will be activated.
Creating a Custom Capacity Configuration
■
Resetting the Capacity Configuration
■
Setting the Default Capacity Policy
■
Displaying the Current Capacity Configuration
■
Resolving Orphaned Cartridges Caused by Capacity Changes
■
See Also
"Updating Hosts After Modifying Capacity"
■
Creating a Custom Capacity Configuration
You cannot use the local operator panel to configure capacity.
To prevent conflicts, coordinate with other library users before configuring the
1.
library.
In SLC, select Tools > Select Active Cells. Select the Module Map tab.
2.
Select a module and click the Select Active Cells tab. To display an adjacent
3.
module, click Move Left or Move Right.
Capacity is automatically applied in a partitioned library. You
Note:
can only configure capacity in a non-partitioned library.
You can click Refresh to discard uncommitted changes and
Note:
restore the last saved configuration. You must apply the configuration
to save it to the library controller.
Configuring Capacity
6
on page 8-1
Configuring Capacity 6-1
6