Displaying Current Hardware Activation Files; Deleting A Hardware Activation File; Installing Legacy Hardware Activation Files - Oracle StorageTek SL3000 Manual

Displaying Current Hardware Activation Files

Click Yes, and then OK.
5.
Verify that the activation file was installed successfully (see
6.
Hardware Activation Files"
You may need to perform additional tasks to use the new feature (see
"Configuring Capacity"
Displaying Current Hardware Activation Files
In SLC, select Tools > Hardware Activation.
1.
Click the Current Hardware Activation Keys tab.
2.

Deleting a Hardware Activation File

Deleting a hardware activation file is rarely necessary and can impact library
operations. Having extra hardware activation files installed on a library does not cause
problems (for example, capacity activation files that exceed the physical capacity of the
library).
In SLC, click Tools > Hardware Activation.
1.
Click the Delete Hardware Activation Files tab.
2.
Select the activation file to delete.
3.
Verify the correct activation file is selected, and then click Delete.
4.
Click Yes.
5.
Depending on the feature of the hardware activation file, you may need to
perform additional tasks after deleting the file (see
page 7-2).

Installing Legacy Hardware Activation Files

For SL3000 libraries with firmware below FRS_3.0, contact Oracle support. All
purchased features are enabled with a single hardware activation file installed by an
Oracle support representative.
If you upgrade to firmware version FRS_3.0 and above, use the process described in
"Installing a New Hardware Activation File"
5-2 StorageTek SL3000 Library Guide
on page 5-2).
on page 6-1 and
To display a feature audit log showing all hardware activation
Note:
activity, use the Reports utility (see
Reports with the Reports Utility"
"Displaying Current
"Partitioning the Library"
"Viewing Library and Device
on page 15-1).
"Deleting a Partition"
on page 5-1.
on page 7-1).
on