Loading Firmware
Loading Firmware
Download the code to the system you will use to run SLC (see
1.
Firmware from My Oracle Support"
Review the pre-requisites and code load instructions provided with the download.
2.
Log in to SLC.
3.
Select Tools > Diagnostics, and then select the Library in the device tree.
4.
Click the Load Code tab.
5.
Click Browse, and then locate the firmware package on your system. Within the
6.
firmware package, select the SL3000_FRS<X.XX>_firmware.jar file.
In the File Load Console Window, verify the file contents contain the FRS version
7.
of code you intend to load.
Click the Load button. The process could take up to 10 minutes as the library loads
8.
and then unpacks the code.
Verify the package unpacked successfully (Failed 0). If there are any failures,
9.
contact Oracle support.
Activating Firmware
If you have not already downloaded and unpacked the code, see
1.
Firmware"
D-2 StorageTek SL3000 Library Guide
This procedure is for upgrading to firmware FRS_4.50 or
Note:
above. The current firmware must be a minimum of FRS_4.40 and SLC
6.65. To install an older version, to downgrade firmware, or if your
current firmware version is below FRS_4.40 contact Oracle support.
Code load is not available at the local operator panel.
Note:
To activate code, the library must reboot. Schedule the
Note:
activation accordingly.
on page D-2.
on page D-1).
"Downloading
"Loading