Rebooting the Local Operator Panel
You may need to reboot the local operator panel if it hangs or the help content is not
visible. You can reboot at the local operator panel or from a remote SLC session.
In SLC, select Tools > Diagnostics.
1.
Select the Library in the device tree, and then click the OpPanel tab.
2.
Click the Reboot Operator Panel button.
3.
If rebooting from the local operator panel, the screen will go blank. The reboot is
4.
complete when the operator panel comes back online.
If rebooting from a remote SLC session, "Reboot Complete" indicates the reboot of
the local operator panel has finished.
Rebooting an AEM Safety Door
Use the Tools > Diagnostics utility to reboot an AEM safety door. You may need to
reboot the door to clear errors when the AEM safety door is in an abnormal condition.
In SLC, select Tools > Diagnostics.
1.
Expand the Safety Door folder, and then select the AEM safety door.
2.
Click Reboot.
3.
If the safety door is online, click OK to take the safety door offline.
4.
Click OK to confirm the reboot. The library controller reboots the safety door. The
5.
safety door re-initializes, and the robot audits the AEM.
Rebooting the Library
Rebooting the library involves reloading the firmware from flash memory and
restarting the library controller.
In SLC, select Tools > Diagnostics.
1.
Select the Library in the device tree.
2.
Click Reboot.
3.
All other users must log off. Click OK.
4.
If the library is online, click OK to take the library offline.
5.
Click OK to reboot the library.
6.
Click OK to terminate this SLC session. Do not log back in to the SLC until the
7.
library has fully initialized.
Changing Online/Offline Status and Rebooting 16-3
Rebooting the Library