Table of Contents
Advertisement
Back Up the Current Configuration Before Upgrading
If, in addition to upgrading the NEM firmware, you also want to enable SAS2
functionality, perform the additional steps noted in
ILOM" on page
Note -
back up the current configuration as described in
Upgrading" on page
Perform these tasks to upgrade the NEM firmware.
"Back Up the Current Configuration Before Upgrading" on page 18
■
"Download the NEM Firmware Package" on page 20
■
"Upgrade the NEM Firmware" on page 21
■
"Enable or Disable SAS2 From Oracle ILOM" on page 23
■
Back Up the Current Configuration Before
Upgrading
Save the current NEM configuration to a remote site before upgrading the NEM software. Refer
to the Sun Blade 6000 Ethernet Switched NEM 24p 10GbE Software Configuration Guide for
additional information.
If the switch is running the 1.1.0.x release, you can also use the backup and restore feature from
Oracle ILOM to save the current Oracle ILOM and SEFOS configurations to a remote server.
You can then restore the switch configuration after upgrading the firmware. See
SEFOS Configuration in Backups" on page
Note -
configuration (y/n)?, the Oracle ILOM and SEFOS configurations is automatically
preserved and there is no need to explicitly restore the configuration. If a syslog server address
was configured in Oracle ILOM, the address is not preserved (see CR 7022286), and you must
reconfigure the syslog server setting after the upgrade or restore.
Configure the default IP address.
1.
a.
Enter Global Configuration mode.
SEFOS#
b.
Configure the default IP address and subnet mask as 10.0.0.100 and
255.255.0.0.
18
Sun Blade 6000 Ethernet Switched NEM 24p 10GbE Release 1.2.2 Product Notes • March 2016
23.
You must be logged in as root to do the upgrade. Before upgrading the switch firmware,
18.
During the upgrade, if you answer yes to the question Preserve existing
configure terminal
"Enable or Disable SAS2 From Oracle
"Back Up the Current Configuration Before
27.
"Include the
Advertisement
Table of Contents
