Dimm Installation - Kontron cPCI-MXS64GX Technical Reference Manual

cPCI-MXS64GX Technical Reference Manual
The recommended DIMM devices are listed in the table below.
Vendor's part number
CTK32M/P100S
4X72CQ2X8S4E
DIM-200472V2S08G1
DIM200472V5S08G
CTK64M/P100S
8X72PC8X8S4E
DIM200872V4S8G1
CTK128M/P100S
DIM-201672V4S08G1
VM374S1723-GL
CFHKQARV4VU420G
CTK256M/P100S
DIM203272VDS08GS
VM374S3323-GL

3.3.3.2. DIMM Installation

NOTE
If a Mezzanine card is installed, it must be removed before installation of
DIMMs.
To install the DIMMs in the sockets, proceed as follows:
1. With the board flat on the table, turn it so that the front plate is facing you.
2. Hold the module vertically so that the bottom connector key is at right. Install the
DIMM straight down into the DIMM socket. The socket's keys will ensure a correct
mating.
3. Press firmly on the top edge of the memory module to engage it into the socket. The
module is fully inserted when the retaining clips snap into notches located at each
end of the module.
If necessary, work your way by inserting the other modules, one by one.
To remove the DIMMs from the sockets, pull simultaneously on the retaining clips located on
each side of the socket. Once the module has snapped out, pull gently on it.
DIMM's description
ECC SDRAM 32MB 4M*72 PC100 1.15"HT
ECC SDRAM 32MB 4M*72 PC100 1.15"HT
ECC SDRAM 32MB 4M*72 PC100 1.15"HT
ECC SDRAM 32MB 4M*72 PC100 1.15"HT
ECC SDRAM 64MB 8M*72 PC100 1.15"HT
ECC SDRAM 64MB 8M*72 PC100 1.15"HT
ECC SDRAM 64MB 8M*72 PC100 1.15"HT
ECC SDRAM 128MB 16M*72 PC100 1.15"
ECC SDRAM 128MB 16M*72 PC100 1.15"
ECC SDRAM 128MB 16M*72 PC100 1.15"
ECC SDRAM 256MB 32M*72 PC100 1.15"
ECC SDRAM 256MB 32M*72 PC100 1.15"
ECC SDRAM 256MB 32M*72 PC100 1.15"
ECC SDRAM 256MB 32M*72 PC100 1.15"
3.18
Vendor's Name
CENTON
ROCKY MOUNTAIN RAM
SHIKATRONICS
SHIKATRONICS
CENTON
ROCKY MOUNTAIN RAM
SHIKATRONICS
CENTON
SHIKATRONICS
VIRTIUM
CENTON
CENTON
SHIKATRONICS
VIRTIUM