Table of Contents
Advertisement
cPCI-MXS64GX Technical Reference Manual
2.3.2. CPCI I/O Configuration
Ethernet 1 and 2 signals are available on CPCI I/O connectors only when the board is ordered
for rear access.
CAUTION
The combination of both front and rear panel configurations is not supported.
The Boot from LAN capability is supported. To enable the option, use the BIOS Setup
program. Please refer to Section 4.1 BIOS Setup Program.
A diskette entitled "Network Drivers for Intel 82559 is included with the cPCI-MXS64GX.
It contains network drivers for most common operating systems.
2.4.
FLOPPY DISK INTERFACE
The onboard floppy disk controller is IBM PC XT/AT compatible. It handles 3.5" and
5.25", low and high density disks. Up to two drives can be supported in any combination.
Signal Paths
The Floppy Disk Controller interface is available through the CPCI I/O connector and
through the Mezzanine connector (see section 1.4.1)
Related Jumpers
None.
BIOS Settings
Section 4.1.4 Standard CMOS: Select type of floppy.
Section 4.1.11 Integrated Peripherals: Enable/Disable onboard FDC Controller.
2.4
Advertisement
Table of Contents
