Table of Contents
Advertisement
!
IMPORTANT
J1 and J2 are de-facto industry standard as defined by PICMG
J3, J4 and J5 are user-defined connectors and will vary from various
manufacturers. Contact our Technical Support to verify pinout
compatibility with other chassis backplane vendors.
!
POWERING-UP THE SYSTEM
If you should encounter a problem, verify the following items:
Make sure that all connectors are properly connected.
Verify your boot diskette.
If the system still does not start up properly, you should try booting your
system with only the power cord and video monitor connected to the board
this is the minimum required to see if the board is working).
If you still are not able to start up your system, please refer to the
emergency Procedure in the Appendix Section.
If you still are not able to get your board up and running, contact our
technical Support department for assistance.
!
PREVENTING VIRUSES
Kontron Communications, Inc takes every precaution against computer
viruses.
To safeguard against computer viruses in general, do not freely lend your
diskettes and regularly perform virus scans on all your computer
systems.
!
ADAPTER CABLES
While adapter cables are provided from various sources, the pinout is often
different. The direct crimp design offered by Kontron allows the simplest
cable assembly. All cables are available from Kontron Sales Department.
Advertisement
Table of Contents
