Table of Contents
Advertisement
2.9.1. SERIAL PORT 1
Serial Port 1 is buffered directly for RS-232 operation. Signals include the complete signal set
for handshaking, modem control, interrupt generation, and data transfer. When assigned as
Serial Port 1, the port is 100% compatible with the IBM-AT serial port in RS-232 mode.
Signal Path
Serial Port 1
signal path depends on the output configuration you have ordered for the
board
Related Jumpers
W5 – Remote reset on Serial Port 1 or Serial Port 2 or disabled
BIOS Settings
Section 4.1.11 Integrated Peripherals : Enable/Disable Onboard FDC Controller;
2.9.1.1. Remote Reset
A remote hardware reset of the cPCI-MXS64GX is possible by sending a break on the Serial
Port 1 or Serial Port 2 (see section 3.1 for Remote Reset jumper setting). A break is simple an
abnormally long start bit (100ms or more) on the incoming data line. A break signal is
embedded in the data, so no special wire is required.
Related Jumpers
W5– Remote reset on Serial Port 1 or Serial Port 2 or disabled to select whether the
serial port 1 or 2 is used to control the remote reset
Bios Settings
None
Select Com Port Address of Serial Port 1
2.9
Onboard Features
Advertisement
Table of Contents
