Kontron cPCI-MXS64GX Technical Reference Manual page 91

Chipset Features Setup (Continued)
BIOS
Option
Defaults
PCI/VGA Palette Dis.
Snoop
Passive Release
Delayed Transaction Dis.
Supervisor I/O Base 190h
Address
Power-Supply Type
AGP Aperture Size
(MB)
Video BIOS Shadow
C8000-CBFFF
CC000-CFFFF
D0000-D3FFF
D4000-D7FFF
D8000-DBFFF
DC000-DFFFF
Setup Possible
Defaults Settings
Dis. En./Dis.
En. En. En./Dis.
Dis. En./Dis.
190h 190h, 290h,
390h
AT AT AT, ATX
64 64 4 to 256
En. En. En./Dis.
En. En. En./Dis.
En. En. En./Dis.
En. En. En./Dis.
En. En. En./Dis.
En. En. En./Dis.
En. En. En./Dis.
Palette snooping allows multiple VGA devices operating on
different buses to handle data from the CPU on each set of palette
registers.
When set to Enabled, data read and written by the CPU is
directed to both the PCI VGA device's palette registers and the
ISA VGA device's palette registers, permitting the palette registers
of both to be identical.
When set to Disabled, data read and written by the CPU is only
directed to the PCI VGA device's palette registers.
When Enabled, CPU to PCI bus accesses are allowed during passive
release otherwise the arbiter only accepts another PCI master access
to local SDRAM.
The chipset has an embedded 32-bit posted write buffer to support
delay transactions cycles. Select Enabled to support compliance with
PCI specifications version 2.1.
This option determines the base address for the Supervisor I/O
Register, which is used for such functions as power fail detection
and the watchdog timer.
This option selects the type of power supply.
This option selects the size in megabytes of the AGP Aperture.
Software that resides in a read-only memory (ROM) chip on a
device is called firmware. Award permits shadowing of firmware
such as the system BIOS, video BIOS, and similar operating
instructions that come with some expansion peripherals.
Shadowing copies from ROM into system RAM, where the CPU
can read it through the 64-bit DRAM bus. Firmware not shadowed
must be read by the system through the 8 or 16-bit ISA bus.
Shadowing improves the performance of the system BIOS and
similar firmware for expansion peripherals.
Enable shadowing into each section of memory separately. Many
system designers hardwire shadowing of the system BIOS and
eliminate a System BIOS Shadow option. Note that on a PCI VGA
card (on board or off-board), the VGA BIOS is always shadowed.
Video BIOS shadows into memory area C0000 plus the VGA
BIOS size. The remaining areas between C0000 and DFFFF
shown on the BIOS Features Setup screen may be occupied by
other expansion card firmware. If an expansion peripheral in your
system contains ROM-based firmware, you need to know the
address range the ROM occupies to shadow it into the correct
area of RAM.
4.9
Software Setups
Description