NEC Aspire S IntraMail System Manual page 186

Unscreened Transfer
Forced Unscreened Transfer (page 85)
The Subscriber Mailbox can optionally convert Automated Attendant Screened Transfers to Unscreened
Transfers.
Next Call Routing Mailbox (page 140)
The Next Call Routing settings for a Subscriber Mailbox may provide additional options after the caller
leaves a message.
Screened Transfer (page 154)
After an Automated Attendant caller dials an extension, IntraMail calls (screens) the destination exten-
sion to see if the transfer can go through.
Programming
Step 1
Step 2
Operation
N/A
176 ◆ Chapter 2: Features
Assign the UTRF action to a key on the active Dial Action Table.
47-13-01: Dial Action Table Actions: UTRF Action - Unscreened Transfer (2) on page 237.
1.1
- Normally, the corresponding Number option should be XXX. Note that the key you choose
for this action is the first digit of the called extension number.
- For example, to allow callers to place Unscreened Transfers to extensions 301-399,
for key 3 enter UTRF for the Action and XXX for the corresponding Number.
- To have Unscreened Transfer call a specific extension, the corresponding Number option
should be that extension's number. The caller then dials that single digit to reach the extension.
- For example, to have callers dial 8 to reach extension 303, for key 8 enter UTRF for
the Action and 303 for the corresponding Number.
✔
By default, key 0 and TIMEOUT are both UTRF actions to 301. In addition, keys 3 and 4
are UTRF actions to XXX.
Optionally set the telephone system's Transfer Recall interval.
24-02-04: Transfer Recall Time
2.1
- Unanswered Unscreened Transfers route to the extension's mailbox after this interval.
✔
By default, this interval is 30 seconds.
IntraMail for Aspire System Guide