Unipulse F350 Operation Manual page 88

2. Send/receive [Setting value writing/reading]
Function
Main
channel
w
switching
Function
Main
Various
w
settings
Function
Main
Various
w
settings
* Command definition
1 1
Setting mode number (F*)
Point
●"Setting protect" and "key protect" can be read but cannot be written.
●"Initialize" and "password" cannot be either read or written.
●When the protect of the setting value you are going to write is ON, it cannot be written. Turn OFF
the protect by key operation.
●If an output value is written in command 42 (zero calibration), simulated zero calibration is
executed with the written value. Also, if an output value is written in command 43 (equivalent input
calibration), equivalent input calibration is executed.
75
Channel selection （Setting value with channel switching）
Header
Sub
Host
F350
－
* For a setting value with ch switching, make sure to write in advance the
channel number selected, and then write or read the setting value.
Setting values without channel switching are disregarded.
The command is fixed at 00.
Setting value writing
Header
Sub
Host
F350
* When the number of digits of the setting value is smaller than five, put a zero in the higher digit(s).
Example) 3 digits
－
* When the setting value is unsigned, put a zero in the sign digit.
* For Motion Detect and Zero Tracking, put a zero in the 3rd digit.
Setting value reading
Header
Sub
Host
F350
－
(A setting value with a decimal point results in the numerical value excluding the decimal point.)
Setting value item number
Protocol
W 0 0 0 0 0
command 0 fixation
00 fixation
Protocol
+
W 1 1 1 2
command Sign, decimal point, 5-digit indicated value.
(For a setting value with a decimal point, simply write
the numerical value excluding the decimal point.)
＊ ＊
W + 0 0
＊ ＊
W 0 0 0
＊ ＊
W 0 1 5
Protocol
W 1 1 CR
W 1 1
command
* The mode number of the setting value of HI/LO limit is "0."
* For setting mode numbers and setting item numbers, see "11-1.
The list of initial setting value" on page 88.
9 OPTION INTERFACE
0 0 1 CR
1 ： ch1 2 ： ch2
3 4 5 CR
1 2 3 CR
0 0 3 CR
Example)Time 1.5sec.
0 1 0 CR
Range 10
＋ 1 2 3 4 5
Delimiter
Sign, decimal point, 5-digit indicated value.
Chapter
9
75