How To Connect And Install The Terminal Block; Attachment Of A Ferrite Core - Unipulse F350 Operation Manual

■How to connect and install the terminal block

1.
2.
3.
4.
5.
6.
7.

■Attachment of a ferrite core

It is necessary to twist a power supply cable and sensor cables, such as a load cell, around an
attached ferrite core.
11
Strip 5mm of the covering of the wire to be
connected.
The size of connectable wires is from 0.21 to
2
3.31mm (AWG12 to 24).
Twist the tip to such an extent that it will not spread out.
Loosen the screw with a screwdriver to open
the connection hole.
*A Phillips screwdriver 3 to 3.5mm #1 in shaft
diameter is recommended. (Precision screwdriver,
etc.)
Insert the wire into the connection hole so as
not to let the tip spread out.
Tighten the screw with the screwdriver.
*0.5Nm of tightening torque is recommended.
Lightly pull the wire to make sure that
it is securely clamped.
Insert the wire-connected plug into
the F350 body, and tighten the
screws (two).
A cable is twisted around
a ferrite core. （One roll）
Sensor cables
2 INSTALLATION & CONNECTION
5mm
Pin No.12
Pin No.1
Adaptable plug ETB42-12P
（attachment）
Tighten.
(Turn clockwise.)
Tighten.
(Turn clockwise.)
Ferrite core
Loosen.
(Turn counterclockwise.)
Tighten.
(Turn clockwise.)
F350
11
Chapter
2