11-3.Setting Protect; Setting Protect Setting Method - Unipulse F350 Operation Manual

11-3.
Setting protect
Each category of setting values can be locked to prevent rewriting.
For each category, see the setting value list.
0：OFF
1：ON
≪Setting value≫
■

Setting protect setting method

1.
2.
3.
Point
95
Enables rewriting of setting values.
Disables rewriting of setting values.
0 0 0
Calibration protect
0 ： OFF 1 ： ON
System protect
0 ： OFF 1 ： ON
Work protect
0 ： OFF 1 ： ON
Select setting mode 9.
Press →
FNC
Set "setting protect."
Press once. ⇒ "Setting protect" is displayed.
Press , and the highest digit blinks.
Input the setting value of "Work protect" with
.
Move to the lower digit with
Input the setting values of "System protect" and
"Calibration protect" in a like manner.
Press to validate it.
Press twice to go back to the indicated value display.
ESC
For the setting items protected by the setting protect, see "11-1.The list of initial
setting value" on page 88.
five times.
.
11 SUPPLEMENTS
Ch1 Ch 2
H I LO
H I LO
H I OK LO PEAK HOLD
Ch1 Ch 2
H I LO H I LO
《Setting value》
0 0 0
Calibration protect
0 ： OFF 1 ： ON
System protect
0 ： OFF 1 ： ON
Work protect
0 ： OFF 1 ： ON
Chapter
11
95