Rear Panel - Unipulse F350 Operation Manual

CAUTION
1 OUTLINE

■Rear panel

Chapter
1
Signal input/output
connector
Analog input/output
connector
Analog input/output connector
Connect a strain gauge sensor or voltage output.
* For connection, see "■ Analog input/output connector connection" on page 10.
Signal input/output connector
Connect external input/output signals or SI/F (serial interface).
* For connection, see "■ External I/O connection" on page 14.
Power input terminal block
Connect an AC input cord.
The input power source is free in the range of 100 to 240V AC (-15%, +10%). The frequency is 50/
60Hz.
* For connection, see "■ Power input terminal connection" on page 9.
Protective ground
Be sure to ground the protective ground terminal to prevent electric shocks.
Frame ground
Please ground the frame ground terminal to prevent failures due to static electricity.
(The frame and the frame ground terminal are conducted.)
It may be better to remove depending on the environment of the installation location.
Options slot
One option board can in stall in the option slot.
・BCD parallel data output
・RS-232C interface
・D/A converter voltage output
・D/A converter current output
6
6
Options slot
Power input terminal
Frame ground
Protective ground
(BCO)
(232)
(DAV)
(DAI)