Output Data Select; Signal Timing - Unipulse F350 Operation Manual

9 OPTION INTERFACE

■Output data select

《Setting value》
◇ Output data select setting method
Chapter
9

■Signal timing

● Minus
● OVER
● STAB
● STROBE
66
66
0：Calculated value
1：ch1 value
2：ch2 value
3：External select
Data select 1
* In the case of external selection, read after at least 2 cycles.
1.
Select setting mode 5.
Press
→
FNC
2.
Set "Output data select."
Press once. ⇒ "Output data select" is displayed.
Press once, and present set value blinks.
Input the setting value with
（Initial value:0）
Press to validate it.
3.
Press twice to go back to the indicated value display.
ESC
Turns on when the output indicated value data is negative.
Turns on at over-scale time.
Turns on at stable-time. See "5-7. Motion Detect" on page 41.
Strobe pulses are output in synchronization with BCD data.
For reading the data, use the rising edges of the pulses when the
logic is negative, and the falling edges of the pulses when the logic
is positive.
The calculated value is output.
The ch1 value is output.
The ch2 value is output.
Data selected by the data select input (A15, B15) is output.
Data select 0
OFF OFF
OFF ON
ON OFF
ON ON
four times.
.
-LOAD、+LOAD、OFL1、OFL2
Output data
Calculated value
(hold synchronized)
ch1 value
ch2 value
Calculated value
(hold not synchronized)
Ch1 Ch 2
H I H I LO
LO
H I OK LO PEAK HOLD
Ch1 Ch 2
H I LO H I LO