Analog Input/Output Connector Connection; How To Remove The Terminal Block - Unipulse F350 Operation Manual

2 INSTALLATION & CONNECTION

■Analog input/output connector connection

Connect a strain gauge sensor or voltage output.
Make connections according to the silk-screen printing on the rear panel of the F350.
●Pin Assignment
Chapter
2

■How to remove the terminal block

10
10
12 SHIELD
11 -MONITOR(ch2)
10 +MONITOR(ch2)
9 -MONITOR(ch1)
8 +MONITOR(ch1)
7 -SIG(ch2)
6 +SIG(ch2)
5 -SIG(ch1)
4 +SIG(ch1)
3 -EXC*
2 +EXC*
1 SHIELD
Compatible connector： ETB42-12P(OSADA CO.,Ltd.) or equivalent
(Connector optional type：CN81)
Before connecting a strain gauge sensor, make sure to check the setting of excitation
voltage.
For the setting of excitation voltage, see "4-2 ②Excitation voltage setting" on page
25.
1.
Loosen the screws (two) with a screwdriver.
2.
Remove the terminal block by giving it a
strong pull.
Attention
When installing the terminal block to the F350
body, check its orientation. (See the illustration at
the right.)
* EXC is common to ch1 and ch2.
CAUTION
Loosen.
(Turn
counterclockwise
.)
Insert side
Right side