Table of Contents
Advertisement
9 OPTION INTERFACE
■Output rate
《Setting value》
* When the A/D conversion speed is 300 times/sec., settings are available up to 4: 300
◇Output rate setting method
Chapter
9
■BCD/binary select
The output data selection can be changed to binary.
68
68
0：10
4：300
1：30
5：500
2：50
6：1000
3：100
【times/sec.】
[times/sec.].
Point
Even if this setting is changed, A/D conversions speed does not change.
Make the output rate slower when reading fails due to a low processing
performance of the device that should receive BCD.
1.
Select setting mode 5.
Press
→
FNC
2.
Set "Output rate."
Press
Twice. ⇒ "Output rate" is displayed.
Press
, and present set value blinks.
Input the setting value with
（Initial value：3）
Press
to validate it.
3.
Press
twice to go back to the indicated value display.
ESC
《Setting value》
0：BCD
1：Binary
four times.
.
Ch1
Ch 2
H I
LO
H I
LO
H I
OK
LO
PEAK
HOLD
Ch1 Ch 2
H I
LO
H I
LO
Advertisement
Table of Contents
