Explanation Of Hold Functions; Hold Functions Of Calculated Values; Flow Of Hold Measurement - Unipulse F350 Operation Manual

7 EXPLANATION OF HOLD FUNCTIONS
7
EXPLANATION OF
HOLD FUNCTIONS
7-1.

Hold functions of calculated values

The hold functions are to take out a specific point of calculated values for HI/LO limit comparison.
Here, the operation of each hold will be described in detail.
0：OFF
1：Sample
2：Peak
3：Bottom
4：Average

■Flow of hold measurement

Chapter
7
50
50
Hold mode
0：All section 1：External signal 2：External signal+Time
1.
Select a hold you want to use.
2.
If the hold has the setting of section, set a section you want to use.
For details, see "7-3.Setting of hold section" on page 54.
3.
Set the special setting value required for the hold used.
4.
After confirmation of wiring, perform hold control by external input, and start
measurement.
Hold section
None
0：All section 1：External signal