Display Rpr Statistics - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Parameters
overall: Integrated ring selection tables, which guide field programmable gate array
(FPGA) to select rings.
static: Static ring selection tables. You can create them manually. Their priority is
higher than that of dynamic ring selection tables. But it takes effect only in closed rings.
dynamic: Dynamic ring selection tables. Topology databases can calculate them
according to the shortest path.
vrrp: VRRP (virtual router redundancy protocol) ring selection tables, which consist of
MAC ring selection entries from integrated ring selection tables when VRRP is
supported.
RprPos: Specifies the interface type RPRPOS.
Rpr10GE: Specifies the interface type RPR10GE.
RprGE: Specifies the interface type RPRGE.
interface-number: Port number.
Description
Use the display rpr rs-table command to display integrated ring selection table
information. Integrated ring selection tables, which are written in CAM (conditional
access module) of the FPGA finally, are generated from static and dynamic ring
selection tables, In the case of closed rings, for the same destination station, the
system selects rings according to the existing static ring selection information.
Otherwise, the system selects rings according to the dynamic ring selection information.
In the case of open rings, static ring selection does not take effect.
Examples
# Display the dynamic ring selection table of RPRPOS 5/1/1.
<H3C> display rpr rs-table dynamic RprPos 5/1/1
Dynamic ringlet selection table of interface: RprPos5/1/1
MAC Address
000f-e255-1006
000f-e211-1116
000f-e239-af18

1.1.10 display rpr statistics

Syntax
display rpr statistics { dmac | smac } mac-address [ { RprPos | Rpr10GE | RprGE }
interface-number ]
Ringlet TTL IP Address
1 1 100.0.0.3
0 2 100.0.0.2
0 1 100.1.1.1
1-21
Chapter 1 RPR Port Configuration Commands
Station Name
S9500-C
S9500-B
S9500-A