Rpr Tunnel Vlan - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Examples
# Bind GigabitEthernet 4/1/1 to RPRPOS 6/1/1. Specify the related VLANs as VLAN 2,
VLAN 7, and VLAN 10. Enable automatic port shutdown.
<H3C> system-view
[H3C] rpr tunnel track GigabitEthernet4/1/1 to RprPos6/1/1 vlan 2 7 10
trigger-shutdown
# Remove a port binding.
[H3C] undo rpr tunnel track GigabitEthernet4/1/1 to RprPos6/1/1
# Remove all the port binding.
<H3C> system-view
[H3C] undo rpr tunnel track

2.1.4 rpr tunnel vlan

Syntax
rpr tunnel vlan vlanid [ range number ] dest-mac mac-address [ priority priority ]
[ mac-address [ priority priority ] ] { ringlet0 | ringlet1 }
rpr tunnel vlan vlanid dest-mac mac-address { ringlet0 | ringlet1 } force-ringlet
[ monitor-port interface-type interface-number ]
undo tunnel vlan vlanid [ range number ]
View
RPR logical interface view
Parameters
vlanid: Start VLAN ID of the VLAN ID range.
range number: Number of the VLANs apart from the start VLAN.
dest-mac mac-address: Destination MAC address of the Layer 2 tunnel. You can
configure up to two destination MAC addresses. If the two destination MAC addresses
are assigned with the same priorities, the first site is preferred.
priority priority: Assign a priority for a destination MAC address tunnel selecting. The
default priority is 0. A bigger value represents a higher priority.
ringlet0: Specifies the ringlet 0 for data transfer.
ringlet1: Specifies the ringlet 1 for data transfer.
force-ringlet: Specifies a ringlet-tunnel binding by force. If the keyword is specified, the
packets in the VLAN are tunneled through the ringlet in the binding if the original ringlet
fails.
Chapter 2 RPR Layer 2 Tunnel Extended Application
2-5
Configuration Commands