H3C S9500 Series Command Manual page 46

Command Manual – RPR
H3C S9500 Series Routing Switches
Parameters
interface-type: Port type.
interface-number: Port number.
bas-Interface: Specifies a BAS port, which can be an Ethernet port or an RPR logical
interface.
rpr-Interface: Specifies an RPR port, which can only be an RPR logical interface.
all: Displays all the port binding information.
Description
Use the display rpr tunnel-track command to display all the port binding configuration
or the binding configurations of a port. When executing this command, you can specify
only an RPR port or a complete collaboration port. However, you cannot only specify a
BAS port.
Examples
# Display the port binding configuration that matches GigabitEthernet 2/1/1 to
RPRPOS 6/1/1.
<H3C> display rpr tunnel-track rpr-interface r6/1/1 to bas-interface g2/1/1
------------------------------
BAS-Interface : GigabitEthernet2/1/1
RPR-Interface : RprPos6/1/1
VLAN:
2 to 4,
18 to 20,
34 to 36,
Trigger-shutdown : enabled
Table 2-2 Description on the fields of the display rpr tunnel-track command
BAS-Interface
RPR-Interface
[ USER_ADM_DOWN ]
VLAN
6 to 8,
22 to 24,
Field
Configured port connected with the BAS
Configured RPR port
The status of the corresponding port.
USER_ADM_DOWN: The port is shut down manually.
BIND_DOWN: The port is shut down by the system
because trigger-shutdown is configured.
LINK_UP: The link is up.
LINK_DOWN:: The link is down because of other
problems.
List of the VLANs bound
Chapter 2 RPR Layer 2 Tunnel Extended Application
[ USER_ADM_DOWN ]
[ LINK_UP ]
10 to 12, 14 to 16,
26 to 28, 30 to 32,
Description
2-3
Configuration Commands