Chapter 2 Rpr Layer 2 Tunnel Extended Application Configuration Commands; Rpr Layer 2 Tunnel Extended Application Configuration Commands; Display Rpr Tunnel-Table - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Chapter 2 RPR Layer 2 Tunnel Extended
Application Configuration Commands
2.1 RPR Layer 2 Tunnel Extended Application Configuration
Commands

2.1.1 display rpr tunnel-table

Syntax
display rpr tunnel-table [ vlan vlanid [ range number ] ] [ valid | invalid ]
[ interface-type interface-number ]
View
Any view
Parameters
vlanid: Start VLAN ID of the VLAN ID range.
range number: Number of the VLANs apart from the start VLAN.
valid: Displays the valid entries only.
invalid: Displays the invalid entries only.
interface-type: Port type.
interface-number: Port number.
Description
Use the display rpr tunnel-table command to display the information about an RPR
tunnel.
This command can also display the information about all the tunnels or display tunnel
information according to VLAN, tunnel state (valid or invalid), or port number.
Examples
# Display the information about all the RPR Layer 2 tunnels.
<H3C> display rpr tunnel-table
Tunnel vlan table of
Vid - Vlan ID, DA - Dest Mac Address, CA - Current Mac Address,
ARi - Actual Ringlet,CRi - Configed Ringlet, F - Force Ringlet,
Chapter 2 RPR Layer 2 Tunnel Extended Application
interface: RprPos4/1/1
2-1
Configuration Commands