Rpr Cross-Ring Slave Backup-Ring - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches

4.1.9 rpr cross-ring slave backup-ring

Syntax
rpr cross-ring slave backup-ring instance instance-id1 [ to instance-id2 ]
undo rpr cross-ring slave backup-ring instance instance-id1 [ to instance-id2 ]
View
RPR logical interface view
Parameters
instance instance-id1: Instance ID of the backup ring, ranging from 0 to 5.
to instance-id2: Specifies an instance ID range together with the parameter instance
instance-id1. The value of instance instance-id2 must be greater than that of the
instance instance-id1.
Description
Use the rpr cross-ring slave backup-ring command to configure the backup ring for
the specified intersecting ring instance(s).
Use the undo rpr cross-ring slave backup-ring command to remove the
configuration.
Note that:
The rpr cross-ring slave backup-ring command also specifies the RPR logical
interface as the slave ring of the intersecting rings.
The undo rpr cross-ring slave backup-ring command does not remove the
slave ring configuration.
Example
# Configure the link where RPR interface RPRPOS 3/1/1 resides as the backup ring of
intersecting ring instance 5.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface RprPos3/1/1
[H3C-RprPos3/1/1] rpr cross-ring slave backup-ring instance 5
Chapter 4 Intersecting RPR Rings Configuration
4-8
Commands