Flag - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Local station topology information of interface:RprPos5/1/1
Mac address:000f-e211-1116
Station name:S9500-D
Ip address:100.0.0.4
Jumbo preference:jumbo
Current protection mode:steer
Protection state on ringlet0:idle
Protection state on ringlet1:idle
Edge status on ringlet0: false
Edge status on ringlet1: false
Sequence number:26
Last known neighbour on ringlet0: 000f-e211-7a16
Last known neighbour on ringlet1: 000f-e219-11a6
Local topology state:topology is valid

1.1.13 flag

Syntax
flag { c2 c2-value | j0 j0-value | j1 j1-value }
undo flag { c2 | j0 | j1 }
View
RPR POS physical port view
Parameters
c2 c2-value: Path signal label byte, which is a high-order path overhead byte, and
indicates the multiplexing structure and message payload of the VC (virtual container)
frame.
j0 j0-value: Regeneration section trace message, which is a section overhead byte,
and checks port connectivity at section level.
j1 j1-value: Higher-order VC-N path trace byte, which is a high-order overhead byte,
and checks port connectivity at path level.
Description
Use the flag command to configure SONET/SDH overhead bytes.
Use the undo flag command to restore the default configuration.
c2 is 0x16 by default.
By default, j0 and j1 both are "H3C".
The c2, j0 and j1 values should be consistent respectively at the receiver and sender.
Otherwise, the system may give alarms.
Chapter 1 RPR Port Configuration Commands
1-25