Rpr Tunnel Track - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Trigger-shutdown

2.1.3 rpr tunnel track

Syntax
rpr tunnel track interface-type interface-number to interface-type interface-number
vlan vlan-list [ trigger-shutdown ]
undo rpr tunnel track [ interface-type interface-number to interface-type
interface-number ]
View
System view
Parameters
interface-type: Port type.
interface-number: Port number.
vlan-list: VLANs to be bound. You can specify separate VLANs or a VLAN range in the
format of vlan-list = { vlanid [ to vlanid ] }&<1-9>. &<1-9> means that you can provide up
to nine separate VLANs or VLAN ranges.
trigger-shutdown: Specifies to shut down the ports bound to a BAS port when the
latter goes down. If you specify this keyword, the ports specified are shut down
automatically when the BAS port bound goes down. Otherwise, you need to shut down
the ports manually.
Description
Use the rpr tunnel track command to bind the port connected with a BAS and
specified RPR ports and specify the related VLANs. Use the undo rpr tunnel track
command to remove the corresponding configuration.
When a BAS port goes down/up, the RPR ports bound to it release a VLAN
reachable/unreachable message to notify the entire network, by which the related RPR
stations decide whether or not to switch Layer 2 tunnels. By specifying the
trigger-shutdown keyword, you can have the BAS port automatically shut down when
the status of specific RPR ports change to trigger port switching on the uplink BAS
device.
Field
Decide whether to shut down the BAS port actively
when the RPR port is not in up state.
Chapter 2 RPR Layer 2 Tunnel Extended Application
Description
2-4
Configuration Commands