Sdh Threshold - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Ringlet1: Configures station weight on Ringlet1.
value: Station weight. The default value is 1.
Description
Use the rpr weight command to configure the station weight. Fairness algorithm uses
station weight to calculate local fairness rate. The default weight is 1.
Use the undo rpr weight command to restore the default weight.
The fairness algorithm calculates the local fairness rate based on the station weight
value. By default, the weight value is 0. In fact, the weight value configured here is the
th
N power of 2, namely weight = 2
range of weight is 1 to 128.
Examples
# Set weight of stations on ringlet0 to 2.
<H3C> system-view
[H3C] interface RprPos2/1/1
[H3C-RprPos2/1/1] rpr weight ringlet0 2

1.1.32 sdh threshold

Syntax
sdh threshold sdber value sfber value
undo sdh threshold
View
RPR POS physical port view
Parameters
sdber value: Threshold index for signal degrade (SD BER). It ranges from 5 to 7 and
defaults to 6. The actual alarm threshold can be obtained by using the following
expression: 10
sfber value: Threshold index for signal failure (SF BER). It ranges from 3 to 5 and
defaults to 4. The actual alarm threshold can be obtained by using the following
expression: 10
Description
Use the sdh threshold command to set the SD threshold and SF threshold.
Use the undo sdh threshold command to restore the default configuration.
The alarm information configured by this command is the overhead in SDH frame
header, which monitors SDH signals at each layer.
value
-value
.
-value
.
1-40
Chapter 1 RPR Port Configuration Commands
, where value ranges 0 to 7. Therefore, the value