Port Link-Aggregation Group - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Parameters
agg-id: ID of the aggregation group, ranging from 1 to 31. The group ID ranges from 1
to 7 if a C-type board is used. Only manual aggregation group can be used for
distributed RPR.
Description
Use the link-aggregation group mode manual command to create a manual
aggregation group for distributed RPR.
Use the undo link-aggregation group command to remove the specified aggregation
group.
Related commands: display rpr link-aggregation.
Note:
The manual aggregation group configuration aggregates two RPR logical interfaces,
implementing board-level protection for distributed RPR.
Examples
# Create manual aggregation group 1 for distributed RPR.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] link-aggregation group 1 mode manual

5.1.4 port link-aggregation group

Syntax
port link-aggregation group agg-id
undo port link-aggregation group
View
RPR logical interface view
Parameters
agg-id: ID of an aggregation group, ranging from 1 to 31. The group ID ranges from 1 to
7 if a C-type board is used. At present only RPR logical interfaces can be added to a
manual aggregation group.
Chapter 5 Distributed RPR Configuration
5-3
Commands