Rpr Protect-Mode; Rpr Rate-Limiter - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
1 packet(s) transmitted
1 packet(s) received
0.00%
round-trip min/avg/max

1.1.24 rpr protect-mode

Syntax
rpr protect-mode { steer | wrap }
undo rpr protect-mode
View
RPR logical interface view
Parameters
steer: The source station sends data in another direction for protection.
wrap: The failure station sends data in loopback mode for protection.
Description
Use the rpr protect-mode command to configure station protection mode as Steer or
Wrap. The default mode is Steer.
Use the undo rpr protect-mode command to restore the steer RPR protection mode.
Examples
# Set the RPR protection mode to Wrap.
<H3C> system-view
[H3C] interface RprPos3/1/1
[H3C-RprPos3/1/1] rpr protect-mode wrap

1.1.25 rpr rate-limiter

Syntax
rpr rate-limiter { high | low | medium | reserved } { ringlet0 | ringlet1 } value
undo rpr rate-limiter { high | low | medium | reserved } { ringlet0 | ringlet1 }
View
RPR logical interface view
Parameters
high: Class A service; the default value is five thousandth.
low: Class C and class B-EIR service.
packet loss
= 2/2/2 ms
Chapter 1 RPR Port Configuration Commands
1-34