Rpr Default-Rs - H3C S9500 Series Command Manual

Command Manual – RPR
H3C S9500 Series Routing Switches
Caution:
GE RPR ports do not support MPLS precedence mapping and IP precedence
mapping.
Examples
# Configure tag priorities 6 and 7 as class A service, priorities 2, 3, 4 and 5 as class B
service, and priorities 0 and 1 as class C service.
<H3C> system-view
[H3C] interface RprPos3/1/1
[H3C-RprPos3/1/1] rpr cos-precedence-map tag 2 2 1 1 1 1 0 0

1.1.22 rpr default-rs

Syntax
rpr default-rs { ringlet0 | ringlet1 }
View
RPR logical interface view
Parameters
ringlet0: Transports broadcast, multicast and Flooding packets over Ringlet0.
Ringlet1: Transports broadcast, multicast and Flooding packets over Ringlet1.
Description
Use the rpr default-rs command to configure the default RPR ring ID. Broadcast,
multicast and Flooding packets are transmitted in the default ring. Note that the default
ring selection is the sending sub-ring.
Examples
# Configure the default RPR ring ID as Ringlet0.
<H3C> system-view
[H3C] interface RprPos2/1/1
[H3C-RprPos2/1/1] rpr default-rs ringlet0
Chapter 1 RPR Port Configuration Commands
1-32